RhinoCo Technology H.264 Guide d'installation télécharger pdf (Page 7)

To Connect Cameras

• Right click to open the menu and select “MAIN MENU”.

• Select “SETTING”

• Select “REMOTE DEVICE”

Adding new Cameras

1. Click IP Search, this will list all cameras connected in the upper panel.

2. Click on the camera you wish to connect and click ‘Add’

Manual Adding

1. Click Manual Add

2. Enter the information about the camera, if you do not know this information, you must manually

setup the camera on another network before connecting.

NOTE:

The NVR will most likely automatically configure the IP address of a camera connected to the

dedicated POE Ports on the back of the device.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Pas de commentaire

RhinoCo Technology H.264 Guide d'installation Page 7